THUNDER TIGER Tiger Bipe 40 Assembly Instructions Manual page 3

Adhesives - You will need two types of adhe-
sives for the Tiger Bipe - Epoxy and Instant
(cyanoacrylate) adhesives. We recommend that
you purchase both 5-minute and 30-minute
epoxy to cut down on assembly time, but you
can get by with only 30-minute epoxy if time is
not important. You will also need a small bottle
of both "Thick" and "Thin" instant adhesive.
Tools - Model assembly can be much easier if
the proper tools are used. Therefore, we have
included in our checklist to the right, a complete
listing of all the tools we used to assemble
our prototype models. As you will notice, many
household tools can be utilized during construction.
Engine - The Thunder Tiger PRO-36 is the ideal
engine for this airplane. It is a quiet running
engine that is easy to start and require no spe-
cial break- in period, is very easy to maintain,
and will last for years.
Flight Equipment - There are several "support"
items that you will need to purchase in order to
get your engine running and your plane in the
air. These are listed at the bottom of the page.
Comprehensive Items Needed
Check List
4-Channel Radio with 4 Standard Servos
5-Minute Epoxy (4 ounces or so)
30-Minute Epoxy (4 ounces or so)
"Thin" Instant Adhesive (1/2 ounce)
"Thick" Instant Adhesive (1/2 ounce)
Hobby Knife and Blades
Epoxy Mixing Sticks and/or Brushes
Sandpaper (150 grit)
Masking Tape
Rubbing Alcohol
Paper Towels
Ruler
90 Degree Triangle
Waxed Paper
Fine-Point, Felt-Tip Pen
Misc. Household Tools
Drill and Bits (1/16", 5/64", 3/32", 5/32", 3/16")
Flight Equipment
Foam Rubber Padding for the radio
Stick on Lead Strip for balancing the plane
3 or 4 Props (see engine instructions)
10%-15% Glow Fuel
Fuel Pump or Bulb
Electric Starter or "Chicken Stick"
Glow Plug Clip and Battery
Extra Glow Plug(s)
3
ITEMS NEEDED