Chrysler 300 2014 Owner's Manual page 393

Preconditions:
• Launch control should not be used on public roads.
Always check track conditions and the surrounding
area.
• Launch Control is not available for the first 500 miles
of vehicle life.
• Launch Control should only be used when the engine
and transmission are at operating temperature.
• Launch Control is intended to be used on dry, paved
road surfaces only. Use on slippery or loose surfaces
may cause damage to vehicle components.
Launch Control is only available when the following
procedure is followed:
1. Press the "ESC OFF" button to put the vehicle into
ESC Partial mode. The "ESC OFF" lamp will illumi-
nate in the cluster.
2. Press the "ESC OFF" button a second time to put the
vehicle into Launch Control. The "ESC OFF" lamp will
remain lit, and the cluster display will read "Launch
Control Enabled".
3. Make sure the vehicle is not moving.
4. Make sure the steering wheel is pointing straight.
5. Hold the brake and make sure the vehicle is in
"Drive".
6. While holding the brake, rapidly apply the accelerator
pedal to wide open throttle. The engine speed will hold
at approximately 1825 RPM for the quickest launch.
• Messages will appear in the cluster EVIC display to
inform the driver if one or more of the above
conditions (3 through 6) have not been met.
7. When conditions 3 through 6 have been met, the
cluster EVIC display will read "Launch Ready Release
Brake".
STARTING AND OPERATING 391
5