Direct Tuning; Automatic Tuning - Sony STR-DE475 Operating Instructions Manual

Direct Tuning

For details on the buttons used in this section, see "Brief
descriptions of buttons used to r
page 35.
1
Press TUNER.
The last r eceived station is tuned in.
2
Press FM or AM to select the FM or AM band.
3
Press D.TUNING on the remote.
4
Press the numeric buttons on the remote to enter
the frequency.
Example 1: FM 102.50 MHz
b b
1 0
Example 2: AM 1350 kHz
(You don't have to enter the last "0" when the tuning interval
is set to 10 kHz)
b b
1 3
If you cannot tune in a station and the
entered numbers flash
Make sur e you've enter ed the right fr
repeat Steps 3 and 4.
If the enter ed numbers still flash, the fr
used in your ar ea.
5
If you've tuned in an AM station, adjust the
direction of the AM loop antenna for optimum
reception.
6
Repeat Steps 2 to 5 to receive other stations.
z
If you try to enter a frequency not covered by the tuning
interval
The entered value is automatically rounded up or down.
This tuning scale for direct tuning differs depending on the area
code as shown in the following table. For details on area codes,
see page 3.
Area code FM tuning scale
U, CA 50 kHz
E2, E3, TW 50 kHz
AU, CN 50 kHz
* To change the AM tuning scale, see page 45.
36 GB
eceive br oadcasts" on
b b
2 5
0
b
5
0
equency . If not,
equency is not
AM tuning scale
10 kHz (can be changed
to 9 kHz)*
9 kHz (can be changed
to 10 kHz)*
9 kHz

Automatic Tuning

For details on the buttons used in this section, see "Brief
descriptions of buttons used to r
page 35.
1
Press TUNER.
The last r eceived station is tuned in.
2
Press FM or AM to select the FM or AM band.
3
Press TUNING + or TUNING –.
Press the + button to scan fr
button to scan fr om high to low
When the receiver reaches either end of the
band
Scanning is r epeated in the same dir
The r eceiver stops scanning whenever a station is
received.
4
To continue scanning, press TUNING + or TUNING –
again.
eceive br oadcasts" on
om low to high; pr ess the –
.
ection.