Huawei AP3010DN-AGN Quick Start Manual page 18

Power-on
The indoor AP supports the DC power supply and PoE power supply. You can select the power supply
mode as required.
1. Checking Before Power-on
After the AP installation is complete, you should check the following items before power-on:
 When the DC power supply is used, ensure that the DC power supply is properly grounded.
 When the PoE power supply is used, ensure that the PoE power supply is properly grounded.
CAUTION
 Indoor APs can be either powered on by the PoE or DC power supply.
 Do not frequently power on and off an AP.
2. Indicator Status
Table 9 Indicator status of the AP3010DN-AGN, AP5010SN-GN, AP5010DN-AGN, AP6010DN-
AGN and AP6010SN-GN
Indicator Color
Green
Green
Green
Red
Status Type
Default
Steady on status
0.5Hz
Running
0.2Hz
4Hz Alarm
Steady on Error
17
Description
• When the system is being powered on, the
indicator is steady green.
• When the system software is running, the
indicator status depends on the software
running result.
The system is running properly, and the
Ethernet connection is correct, and STAs are
associated with the AP.
The system is running properly, and the
Ethernet connection is correct. However, no
user connects to the AP.
The CAPWAP link is disconnected during an
upgrade.
A fault that affects services has occurred and
cannot be rectified automatically. For
example, the system fails to load the DRAM
or system software. The fault needs to be
rectified manually.