Advertisement
A small crack or chip may break the glass. The glass may not
break immediately after the impact, but may break
unexpectedly as a result. If you find a small crack or chip,
consult your nearest Sony dealer.
Avoid extreme temperature changes
The organic glass tube is not heat-resistant glass. Do not place
hot objects on top of or close to the organic glass tube. An
extreme temperature change may cause it to break.
Notes on caring for the organic glass tube
Avoid scrubbing the organic glass tube. Dust off the organic
glass tube with a soft brush or soft feather broom, and then
lightly wipe the organic glass tube with the cleaning cloth
(supplied). (Do not use a scrubbing brush or a sponge.)
Remove any fingerprints or oil stains by lightly breathing on the
surface and wiping with the cleaning cloth (supplied).
In the case of stubborn stains/marks, use a soft cloth lightly
moistened with warm soapy water.
To avoid damaging the surface finish, do not use detergents,
thinners, benzene, or alcohol.
Do not dismantle the unit as dust may accumulate in the glass
tube.
Avoiding breaking the unit
Do not dismantle or modify the unit.
Lower the volume to a minimum before you turn on/off the unit,
or change the input source.
Do not input the following signals continuously:
– white noise from FM broadcasts.
– continuous high frequency signals, such as from electronic
instruments.
– high level, and high frequency signals typically output from a
tape deck while fast-forwarding.
Note on the light in the organic glass tube
Do not look at the light source directly.
Troubleshooting
If you experience any of the following difficulties while using the
system, use this troubleshooting guide to help remedy the
problem before requesting repairs. Should any problem persist,
consult your nearest Sony dealer.
No sound is output from the system.
The power of the system is off.
Check the power of the system.
Playback component is not connected correctly.
Check that the component is connected correctly.
Volume of the system is low.
Check the volume of the system.
Input source of the system is not selected.
Select the input of the system correctly.
The settings on a digitally-connected component is not set to
Linear PCM.
Check that a digitally-connected component is set to Linear
PCM.
There is hum or noise.
Playback component is not connected correctly.
Check that the component is connected correctly.
Audio components are placed near other components that are
causing noise (TV set, etc.).
Place the audio components farther away from the TV set, etc.
Color irregularity occurs on TV monitor.
Place the system farther away from the TV set.
Three INPUT SELECT indicators flash at the same time.
Turn off the system, unplug the AC power cord (mains lead), and
then consult your nearest Sony dealer.
15
Advertisement
