Caring For Your Steam Pocket Mop - Shark KLIK N' FLIP S6001ANZ Owner's Manual

Caring for Your Steam Pocket
fig. 12
AFTER USE AND STORAGE
1
Unplug the cord from the outlet and place the Steam
Mop into the upright position. Let it cool.
2
To remove the Dirt Grip
straight up by the handle until the Klik n' Flip
Head is hanging straight down. Press the Release
button on the back of the Steam Mop body, and both
sides of the Klik n' Flip Mop Head will drop open,
releasing the pad. Once the pad has been released,
close the Klik n' Flip Mop Head.
3
If the Klik n' Flip Mop Head is not attached to the
Steam Mop, the pad can still be removed. Press the
two red secondary pad release buttons located on
the sides of the Klik n' Flip Mop Head post to release
the pad. (fig. 12)
4
Empty the water tank before storing. To empty the
tank, hold the Steam Mop beside a sink. Open the
water tank lid, then lean the unit over the sink. Let
the water drain out, then close the lid.
5
To store the Steam Mop, wait until after it has cooled
and the steam has been released. Then remove the
Klik n' Flip Mop Head and hang the Steam Mop by its
handle on a large hook (not included). (fig. 13)
6
Store the filling flask by attaching it to the top handle
pole of the Steam Mop.
9 CUSTOMER CARE - NZ: 0800 002 999
®
fig. 13
pad, lift the Steam Mop
™
Mop
™
Mop
fig. 14
fig. 15
DIRT GRIP PAD CARE INSTRUCTIONS
Care
Machine-wash the Dirt Grip pads separately with warm
water using liquid detergent.
NEVER USE BLEACH, POWDERED DETERGENT, OR
FABRIC SOFTENERS as they may damage or leave
a coating on the Dirt Grip pads that will reduce their
cleaning performance and absorbency. Dirt Grip pads
should be line-dried or tumble-dried on a low setting, as
this will extend the life of the microfibre fabric. (fig. 14)
Loose fibres can indicate wearing of the microfibre
fabric. Do not pull the loose fibres, as this can cause the
weave to come undone. Simply trim the loose fibres with
scissors. (fig. 15)
Replacement Dirt Grip pads
For best cleaning results, we recommend replacing your
Dirt Grip pads every 3 to 4 months following normal use.
As with any fabric, dirt particles, grease, friction, and
repeated washing can cause the fibres to break down,
and you may notice an increase in the effort needed to
push or pull the Steam Mop.
You can purchase replacement Dirt Grip pads and other
accessories by calling AU: 1800 890 840 or
NZ: 0800 002 999.
STEAM NOZZLE CARE
If you believe the main steam nozzle or the Steam
Blaster nozzle is clogged, please Customer Care AU:
™
1800 890 840 or NZ: 0800 002 999.