Table of Contents
Advertisement
When tightening RF Type-N connectors located on the rear of the BDA, use a dedicated N-
Type torque wrench. If Type-N connectors are over-tightened, irreparable damage will
occur. Do not use adjustable pliers to loosen or tighten connectors.
When connecting or disconnecting the fiber optic cable connectors located on the front panel
of the fiber optic transceiver module, exercise caution not to touch the optical connector
center pin. In the event that the connector center pin needs cleaning, use only high quality
lens-grade tissue, moistened with isopropyl alcohol.
DWG NO:
Error! Not a valid link.
400/800 MHz Fiber Optic & RF Fed Bi-Directional
Wireless Innovations Group
2601 Telecom Parkway
Richardson, Texas 75082
Rev:
Error!
Not a
valid
link.
Amplifier Operations / Maintenance Manual
Date:06/16/2004
67 of 63
Page:
Advertisement
Table of Contents
