Table of Contents
Advertisement
The minimum tools and test equipment listed below are needed to successfully service the
BDA:
Spectrum Analyzer:
Signal Generator:
Attenuator:
Optical Meter:
Test cable x 2:
Test cable x 2:
Hand tools:
7.4 Module Care
The EOCell Amplifier module, Fiber Optic Transceiver module +48V Power Supply module
and optional Alarm module contain semiconductor devices that are susceptible to damage
from electrostatic discharge (ESD). Correct handling of modules is mandatory to ensure
long-term reliability.
Furthermore, to prevent electrical damage to modules during the removal or installation
process, disconnect the BDA from the AC power source.
7.4.1 Module Removal
1 Verify that AC power to the BDA has been removed.
2 Disconnect the system RF or fiber optic cable as required.
3 Loosen the module's top and bottom wedge locks using a 9/64"allen wrench. (Not
Applicable for Duplexer Module).
4 Loosen the module's front plate screws.
5 Slowly but firmly, pull the module straight out of the chassis. Take care not to twist or
turn the module during withdrawal. The RF connectors on the rear of the module are
easily damaged if handled carelessly.
7.4.2 Module Installation
1 Verify that AC power to the BDA has been removed.
2 Carefully align module into its location and then slowly push the module directly straight
fully into its position. Take care not to twist or turn module during installation.
3 Fasten front plate module screws.
4 Tighten module top and bottom wedge locks using a 9/64" allen wrench. (Not Applicable
for Duplexer Module).
5 Verify all modules are connected prior to applying AC power.
6 Connect the system RF and Fiber Optic cables to BDA.
DWG NO:
Error! Not a valid link.
100kHz to 2GHz
30MHz to 2GHz
20dB, 10W, DC-2GHz, (N male – N female)
Universal Volt-Watts
N male – N male, 2M long RG214
SMA male – N male, 1m long RG223
Philips tip screwdriver
SMA torque wrench
400/800 MHz Fiber Optic & RF Fed Bi-Directional
Wireless Innovations Group
2601 Telecom Parkway
Richardson, Texas 75082
Rev:
Error!
Not a
valid
link.
Amplifier Operations / Maintenance Manual
Date:06/16/2004
65 of 63
Page:
Advertisement
Table of Contents
