Fuse Replacement - KYMCO SPADE 150i Owner's Manual

Fuse Replacement

<For Removal>
Lift off upper cover of fuse case, remove the fuse.
Defective fuse contact tends to generate heat that leads to
malfunctioning.
<For Assembling>
Insert Fuse into Fuse Holder and engage upper cover by
pressing it down.
Try to pull the wire after installing fuse; any slackening
may result in heat generation that leads to malfunctioning;
verify this with special care.
Fuse Holder
<Removal>
Wire
<Assemble>
CAUTION

Never use a fuse other than the specified rating; which
was a main cause for a burnt wiring.

Use genuine KYMCO parts when replacing Electrical
Parts (lights, meters). When non-KYMCO parts are
used, fuses are prone to be blown and battery loading
will become unbalanced.

In the event of a blown fuse, find out the cause before
replacing it, otherwise it may burn again.

Go to a KYMCO dealer or service center for check-up
if the cause cannot be identified.

By all means avoid using a power water jet for cleaning
hood peripherals when washing the vehicle.
7-4
Fuse Holder
7