Lna Assembly; Figure 2-27. Installation Of The Redundant Lna Assembly - Comtech EF Data CSAT-5060 Installation And Operation Manual

100W C-Band Transceiver
Installation
2.7 LNA A
SSEMBLY
Install assembled Redundant LNA assembly (Figure 2-26), as follows:
1. Remove the protective cover from the antenna OMT.
2. Install the appropriate gasket (2, Figure 2-15) on the antenna end of the TRF.
a. If only one of the mounting surfaces has a groove, use the half-thick
b. If both mounting surfaces have grooves, use the full thick gasket (5).
3. Position the LNA switch assembly (with gasket) in place on the antenna and
fasten using the supplied hardware.
gasket.(2)
Figure 2-27. Installation of the
Redundant LNA Assembly.
2-27
Revision 0
MN/CSAT5060100.IOM