Wiring Connections - Power Acoustik PADVD-220 Owner's Manual

Wiring Connections

Make sure you have good chassis ground. A good ground connection will eliminate most electrical
noise problems. A good chassis ground requires a tight connection to the vehicle's metal chassis.
The area around the ground connection should be clean, bare metal without rust, paint, plastic, dust,
or dirt for a good electrical connection.
Using the ISO Connector
1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated.
2. For connections without the ISO connectors, check the wiring in the vehicle carefully before
connecting, incorrect connection may cause serious damage to this unit.
3. Cut the connector, connect the colored leads of the power cord to the car battery as shown in the
color code table below for speaker and power cable connections.
Location Function
Connector A
1
2
3
4 Battery 12V (+)/yellow
5 Auto Antenna/blue
6
7 ACC+/red
8 Ground/black
Connector B
Rear Right(+)---Purple
Rear Right(-)---Purple/Black Stripe
Front Right(+)---Grey
Front Right(-)---Grey/Black Stripe
Front Left(+)---White
Front Left((-)---White/Black Stripe
Rear Left(+)---Green
Rear Left(-)---Green/Black Stripe
Page- 5
**TV antenna is for
PADVD-220T only.