Poulan Pro HDF550M Owner's Manual page 4

ASSEMBLY
Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier, Standard
wrench sizes are listed.
(1) Utility knife
(1) Screwdriver
(2) 1/2" wrenches
OPERATOR'S POSITION (See Fig. 1)
When right or left hand is mentioned in this manual, it
means when you are in the operating position (standing
behind tiller handles).
LEFT
FRONT
RIGHT
OPERATOR'S POSI-
TION
FIG. 1
li li!i!ili!l!l!i!l!l!!!
(2) Hex Bolts 5/16-18 x 3/4
iili!i!i!ilt!i!i!i!t!i!i!i!i!i!t!i !l!l!l
(2) He× Bolts 5/16-18 x t-1/4
CONTENTS OF HARDWARE PACK
i!ii!i ti!i!ilt3i3t!l!i!i3i!i!i3!
(2) Hex Bolts 5/16-18 x 1
(6) Lock Washers 5/16
(4) Washers 3/8 x 7/8 x 14
©
(6) Hex Nuts 5/16-18
4