Table of Contents
Advertisement
ASSEMBLY
i
i
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes,
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly
easier.
Standard
wrench
sizes are listed.
(1) 3/4" wrench
Pliers
(2) 7/16" wrenches
Tire pressure
gauge
Utility
knife
When right or left hand is mentioned
in this manual, it means
when you are in the operating
position
(seated behind the
steering
wheel).
TO REMOVE TRACTOR
FROM CAR-
TON
UNPACK
CARTON
•
Remove all accessible loose parts and parts cartons
from carton.
•
Cut along dotted lines on all four panels of carton.
Remove end panels and lay side panels flat.
•
Check for any additional loose parts or cartons and
remove.
BEFORE REMOVINGTRACTOR
FROM
SKID
ATTACH STEERING
WHEEL
(See Fig. 1 )
ASSEMBLE
EXTENSION
SHAFT
AND BOOT
•
Slide extension shaft onto lower steering
shaft.
Align
mounting holes in extension and lower shafts and install
1/4 hex bolt and Iocknut. Tighten securely.
IMPORTANT: TIGHTEN BOLT AND NUT SECURELY TO 10-12
FT. LBS TORQUE.
Place tabs of steering boot over tab slots in dash and push
down to secure.
INSTALL
STEERING
WHEEL
•
Position front wheels of the tractor so they are pointing
straight forward.
Remove steering wheel adapter from steering wheel and
slide adapter onto steering shaft extension.
•
Position steering wheel so cross bars are horizontal (left to
right) and slide inside beet and onto adapter.
Assemble large flat washer, 1/2 hex nut and tighten se-
curely.
•
Snap steering wheel insert into center of steering wheel.
Remove protective materials from tractor hood and grill.
IMPORTANT:
CHECK FOR AND REMOVE ANY STAPLES
IN SKID THAT MAY PUNCTURE
TIRES WHERE TRACTOR
IS TO ROLL OFF SKID.
FIG. 1
6
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
