Assembly; Service And Adjustments - Poulan Pro DB27H48YT Operator's Manual

SERVICE AND ADJUSTMENTS
REPLACING BATTERY (See Fig. 30) TO REPLACE FUSE
Replace with 20 amp automotive-type plug-in fuse, The
fuse holder is located behind the dash.
&
WARNING: Do not short battery
terminals by allowing a wrench or any
other object to contact both terminals
at the same time. Before connect-
ing battery, remove metal bracelets,
wristwatch bands, rings, etc.
Positive terminal must be connected
first to prevent sparking from acci-
dental grounding.
• Lift hood to raised position,
• Remove terminal guard.
• Disconnect BLACK battery cable then RED battery
cable and carefully remove battery from tractor.
• Install new battery with terminals in same position as
old battery.
• Reinstall terminal guard,
• First connect RED battery cable to positive (+) battery
terminal with hex bolt and keps nut as shown, Tighten
securely.
• Connect BLACK grounding cable to negative (-) battery
terminal with remaining hex bolt and keps nut, Tighten
securely
• Close terminal access doors,
• Close hood,
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 31)
• Raise hood.
• Unsnap headlight wire connector,
• Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor,
• To replace, reverse above procedure,
HEADLIGHT
WIRE
CONNECTOR
KEPS NUT
TERMINAL
ACCESS
DOOR _
HEX BOLT
POSITIVE
CABLE
TERMINAL
GUARD
FIG. 30
NEGATIVE
(BLACK)
CABLE
TO REPLACE HEADLIGHT BULB
• Raise hood,
• Pull bulb holder out of the hole in the backside of the
grill.
• Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill,
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
• Check wiring. See electrical wiring diagram in the
Repair Parts section,
FIG. 31
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at the factory and
adjustment should not be necessary. If adjustment is nec-
essary, see engine manual,
TO ADJUST CHOKE CONTROL
The choke control has been preset at the factory and ad-
justment should not be necessary. If adjustment is neces-
sary, see engne manual,
TO ADJUST CARBURETOR
Your carburetor is not adjustable, If your engine does not
operate properly due to suspected carburetor problems,
take your tractor to an authorized service center for repair
and/or adjustment,
26