Siemens SCALANCE S612 Commissioning And Hardware Installation Manual page 50

Approvals
Personal injury and property damage can occur
The installation of expansions that are not approved for SIMATIC NET products or their
target systems may violate the requirements and regulations for safety and electromagnetic
compatibility.
Only use expansions that are approved for the system.
● Keep to the installation guidelines
The devices meet the requirements if you adhere to the installation and safety
instructions contained in this documentation and in the following documentation when
installing and operating the devices.
● You can always find the latest documentation on the Internet
The current descriptions of the currently available products can always be found on the
Internet under the specified entry IDs/Internet pages:
– "Industrial Ethernet / PROFINET Industrial Ethernet" System Manual
– "Industrial Ethernet / PROFINET - Passive network components" System Manual
– "EMC Installation Guidelines" configuration manual
● Working on the device
To protect the device from electrostatic discharge, personnel must first discharge any
electrostatic charge from their body before touching the device.
Note
The test was performed with a device and a connected communications partner that also
meets the requirements of the standards listed above.
When operating the device with a communications partner that does not comply with
these standards, adherence to the corresponding values cannot be guaranteed.
EU declaration of conformity
You will find EC declaration of conformity for these products on the Internet pages of
Siemens Industry Online Support
(https://support.industry.siemens.com/cs/ww/en/view/66920341).
Notes for the Manufacturers of Machines
This product is not a machine in the sense of the EC Machinery Directive. There is therefore
no declaration of conformity relating to the EC Machinery Directive for this product. If the
product is part of the equipment of a machine, it must be included in the procedure for
obtaining the declaration of conformity by the manufacturer of the machine.
50
WARNING
60612658 (http://support.automation.siemens.com/WW/view/en/60612658)
Commissioning and Hardware Installation Manual, 05/2016, C79000-G8976-C266-06
SCALANCE S