Xconfiguration Network [1] Ieee8021X Eap Md5; Xconfiguration Network [1] Ieee8021X Eap Ttls; Xconfiguration Network [1] Ieee8021X Eap Tls; Xconfiguration Network [1] Ieee8021X Eap Peap - Cisco TelePresence DX70 Reference Manual

Cisco TelePresence DX70 and DX80

Introduction

xConfiguration Network [1] IEEE8021X Eap Md5

Define the Md5 (Message-Digest Algorithm 5) mode. This is a Challenge Handshake
Authentication Protocol that relies on a shared secret. Md5 is a Weak security.
Requires user role: ADMIN, USER
Default value: On
USAGE:
xConfiguration Network n IEEE8021X Eap Md5:
where
n
: Index that identifies the network. Range: 1..1
Md5
: Off/On
Off: The EAP-MD5 protocol is disabled.
On: The EAP-MD5 protocol is enabled (default).

xConfiguration Network [1] IEEE8021X Eap Ttls

Define the TTLS (Tunneled Transport Layer Security) mode. Authenticates LAN clients without
the need for client certificates. Developed by Funk Software and Certicom. Usually supported
by Agere Systems, Proxim and Avaya.
Requires user role: ADMIN, USER
Default value: On
USAGE:
xConfiguration Network n IEEE8021X Eap Ttls:
where
n
: Index that identifies the network. Range: 1..1
Ttls
: Off/On
Off: The EAP-TTLS protocol is disabled.
On: The EAP-TTLS protocol is enabled (default).
D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration xConfiguration
Md5
Ttls
xCommand

xConfiguration Network [1] IEEE8021X Eap Tls

Enable or disable the use of EAP-TLS (Transport Layer Security) for IEEE802.1x connec-
tions. The EAP-TLS protocol, defined in RFC 5216, is considered one of the most secure EAP
standards. LAN clients are authenticated using client certificates.
Requires user role: ADMIN, USER
Default value: On
USAGE:
xConfiguration Network n IEEE8021X Eap Tls:
where
n
: Index that identifies the network. Range: 1..1
Tls
: Off/On
Off: The EAP-TLS protocol is disabled.
On: The EAP-TLS protocol is enabled (default).

xConfiguration Network [1] IEEE8021X Eap Peap

Define the Peap (Protected Extensible Authentication Protocol) mode. Authenticates LAN
clients without the need for client certificates. Developed by Microsoft, Cisco and RSA Security.
Requires user role: ADMIN, USER
Default value: On
USAGE:
xConfiguration Network n IEEE8021X Eap Peap:
where
n
: Index that identifies the network. Range: 1..1
Peap
: Off/On
Off: The EAP-PEAP protocol is disabled.
On: The EAP-PEAP protocol is enabled (default).
53
API Reference Guide
xStatus Appendices
Tls
Peap
Copyright © 2017 Cisco Systems, Inc. All rights reserved.