Adjusting Color Uniformity - Epson BrightLink Pro 1470Ui User Manual

3. Aim the remote control at that projector.
4. Hold down the ID button on the remote control while you press the numeric button that matches the
projector's ID. Then release the buttons.
5. Press the ID button on the remote control to check if the ID-setting process worked.
You see a message displayed by the projector.
• If the remote control is listed as On, the remote control ID is set to operate only the listed projector.
• If the remote control is listed as Off, the remote control ID is not set properly. Repeat the steps
above to set the ID to match the projector you want to control.
Parent topic:

Adjusting Color Uniformity

If the color tone is uneven on each screen, adjust the color tone balance in the Extended menu of each
projector. (The color tone may not be uniform even after performing color uniformity.)
Note: If you cannot adjust color uniformity, make sure the Color Mode setting is not set to Dynamic.
(The Color Mode for both projectors should be set to Presentation.)
Projector Identification System for Multiple Projector Control
151