Starting A Warm Engine; Starting A Flooded Engine; Operating Instructions - Poulan Pro 952711879 Instruction Manual

4. Pull starter rope handle sharply until en-
gine starts and runs.
5. Allow unit to run for 10- -15 seconds, then
fully squeeze the throttle trigger to disen-
gage the starting system.

STARTING A WARM ENGINE

1. Squeeze and hold the throttle trigger.
Keep throttle trigger fully squeezed until
engine runs smoothly.
2. Pull starter rope sharply while squeezing
throttle trigger until engine runs.
NOTE:
Normally, the warm starting proce-
dure can be used within 5- -10 minutes after
the unit is turned off. If the unit sits for more
than 10 minutes without being ran, it will be
necessary to start the unit by following the
steps under STARTING A COLD ENGINE or
following the starting instruction steps shown
on the unit.

STARTING A FLOODED ENGINE

Flooded engines can be started by placing
the start lever to the RUN position. Fully
squeeze throttle trigger. Pull the starter han-
dle repeatedly while squeezing throttle trigger
until engine starts and runs. This could re-
quire pulling the starter handle many times,
depending on how badly the unit is flooded.
If the unit still doesn't start, refer to
TROUBLESHOOTING TABLE
1-800-554-6723.
OPERATING THE COUPLER
This model is equipped with a coupler which
enables optional attachments to be installed.
The optional attachments are:
Edger . . . . . . . . . . . . . . . . . . . . .
Cultivator . . . . . . . . . . . . . . . . . .
Blower . . . . . . . . . . . . . . . . . . . .
Brushcutter . . . . . . . . . . . . . . . .
Pruner . . . . . . . . . . . . . . . . . . . .
WARNING:
Always stop unit and dis-
connect spark plug before removing or instal-
ling attachments.
REMOVING TRIMMER ATTACH-
MENT (OR OTHER OPTIONAL
ATTACHMENTS)
CAUTION:
When removing or installing at-
tachments, place the unit on a flat surface for
stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Coupler
Attachment
TIGHTEN
2. Press and hold the locking/release button.
Locking/Release
Button
Attachment
3. While securely holding the engine and
upper shaft, pull the attachment straight
out of the coupler.
INSTALLING OPTIONAL ATTACH-
MENTS
1. Remove the shaft cap from the attach-
ment (if present).
2. Position locking/release button of attach-
ment into guide recess of coupler.
3. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
4. Before using the unit, tighten the knob se-
curely by turning clockwise.
or call
WARNING:
release button is locked in the primary hole
MODEL:
and the knob is securely tightened before op-
PP1000E
erating the unit. All attachments are designed
PP2000T
to be used in the primary hole unless otherwise
PP3000B
stated in the applicable attachment instruction
PP4000C
manual. Using the wrong hole could lead to seri-
PP5000P
ous injury or damage to the unit.
Locking/Release
Button in Primary Hole

OPERATING INSTRUCTIONS

It is recommended that the engine not be
operated for longer than 1 minute at full
throttle.
LOOSEN
Knob
11
Upper Shaft
Coupler
Coupler Primary Hole
Guide Recess
Locking/
Upper
Attachment
Release
Shaft
Button
Make sure the locking/