Sunbeam Imperial Court User Manual page 20

Q My warming blanket/warming mattress pad/warming
throw doesn't heat properly.
A Check to make sure the cord is plugged into the module
and the power cord is firmly connected to the wall outlet.
Check that the control is "On". If the system still fails to heat, try the following
test to see if it is operating.
1 Fold the warming blanket, warming mattress pad, or warming throw 3 times over.
2 Connect the control to the module and plug the power cord into an outlet.
3 Turn the control to the highest setting and wait five to seven minutes.
4 Put your hand between the folds and you should feel the blanket/ mattress
pad/throw warming. Note: Remember, the warming product is not a heating pad.
It will not feel hot to the touch when laid out flat in a normal manner.
Caution: Do not continue the test for more than seven minutes. DO NOT attempt to
make any internal adjustments to this appliance. If you have tried all of the
solutions above and the warming product still doesn't work, stop using it
immediately, disconnect the power cord and contact our consumer service at the 800
number listed under How to Obtain Warranty Service.
Q What does "FF" mean on my Electronic Digital Control?
A The digital controls are designed to notify you in the event that
a problem has been discovered by flashing "FF" on the display.
Follow instructions on the flag tag to reset control. First, check
the blanket/mattress pad for visual damage. If no visual
Models DD3, DD2,
damage is found, unplug the system from wall outlet. Check
that the control is well connected to the module. Plug the
power cord into the wall outlet. Set the control to "On." If the
18
system still does not operate after 2 or 3 times trying to reset, disconnect the
power cord and contact consumer service at 800-892-7684.
Q What does a flashing light mean on my throw LED control or DD Gradient control?
A The throw control and DD Gradient control is designed to notify you in the event
that a problem has been discovered by flashing the light on the display. Follow
instructions on the flag tag to reset control. First, check the blanket/mattress
pad/throw for visual damage. If no visual damage is found, unplug the system
from wall outlet. Check that the control is well connected to the module. Plug the
power cord into the wall outlet. Set the control to "On." If the system still does not
operate after 2 or 3 times trying to reset, disconnect the power cord and contact
consumer service at 800-892-7684.
Q I have experienced some shedding of the fabric fibers of my warming
blanket/warming throw, what do I do?
A Shedding is normal. If it becomes bothersome, follow the use and care instructions
to wash and dry your warming blanket/warming throw.
FF
DDZ, DDW