Need Assistance - Poulan Pro 530088894 Operator's Manual

S Wind the line evenly and tightly onto the
spool. Wind in the direction of the arrows
found on the spool.
S Push the lines into the notches, leaving 3 to
5 inches (7 -- 12 cm) unwound.
S Insert the lines into the the exit holes in the
hub as shown in the illustration.
S Align notches with the line exit holes.
S Push the spool into the hub until it snaps
into place.
S Pull the lines extending outside of the hub to
release the lines from the notches.
SERVICE
We recommend all service and adjustments
not listed in this manual be performed by an
Authorized Service Dealer.
TROUBLESHOOTING TABLE
WARNING:
Always stop unit and disconnect spark plug before performing any of the
recommended remedies below other than remedies that require operation of the unit.
TROUBLE CAUSE
Engine will not S Engine flooded.
S Fuel tank empty.
start.
S Spark plug not firing.
S Fuel not reaching carburetor.
S Carburetor requires adjustment.
Engine will not
S Carburetor requires adjustment.
S Throttle trigger screw too
idle properly.
tight.
Engine will not
S Air filter dirty.
S Spark plug fouled.
accelerate,
S Carburetor requires adjustment.
lacks power,
or dies under
a load.
S Fuel mixture incorrect.
Engine
smokes
S Air filter dirty.
excessively.
S Carburetor requires adjustment.
Line does not
S Line improperly routed in head.
advance or S Line improperly wound on
spool.
breaks while
S Line size incorrect.
cutting.
S Line size incorrect.
Line welds
S Incorrect spool.
onto spool.
S Line is being crowded against
material being cut.
Line pulls
S Too little line outside of head.
back into
S Line size incorrect.
head.
CARBURETOR ADJUSTMENT
Your carburetor is equipped with limiter caps.
Damage will occur if you turn the needles be-
yond the limiter caps. Adjusting the carburetor is
a complicated task. We recommend that you
take your unit to an Authorized Service Dealer.
SPARK PLUG
Replace spark plug yearly with a Champion
RCJ-8Y plug. Spark plug gap is 0.025 inch.
IGNITION TIMING
Ignition timing is fixed, non-adjustable.

NEED ASSISTANCE?

NEED ASSISTANCE?
Call 1-800-554-6723.
NEED SERVICE PART?
Contact your dealer.
REMEDY
S See "Starting."
S Fill tank with correct fuel mixture.
S Install new spark plug.
S Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
S See "Carburetor Adjustments."
S See "Carburetor Adjustments."
S Loosen screw.
S Clean or replace air filter.
S Clean or replace spark plug; re-gap.
S See "Carburetor Adjustments."
S Empty fuel tank and refill with
correct fuel mixture.
S Clean or replace air filter.
S See "Carburetor Adjustments."
S Check line routing.
S Rewind line tightly and evenly.
S Use only 0.080" (2 mm) dia. line.
S Use only 0.080" (2 mm) dia. line.
S Replace with correct spool.
S Cut with tip of line fully extended.
S Remove spool and pull 4 inches
(10 cm) of line outside of head.
S Use only 0.080" (2 mm) dia. line.
9