Page 1
Tout défaut de le faire pourrait entraîner des blessures graves. Electrolux Home Products North America Div. of WCI Outdoor Products, Inc. Augusta, GA 30907 Copyright E2000 WCI Outdoor Products, Inc. PP196 530088847 11/20/00...
Thrown Protection Objects Leg Guards Boots WARNING: Hazard zone for thrown objects. Blade/Trimmer line can throw objects violently. Others can be blinded or injured. Keep people and animals 50 feet (15 meters) away. Hazard Zone 50 Feet (15 Meters) WARNING: Do not use trimmer head as a fastening device for the blade.
Page 3
S Maintain unit according to recommended procedures. Keep blade sharp. Keep cut- ting line at the proper length. S Use only 0.080” (2 mm) diameter Poulan brand line. Never use wire, rope, string, etc. S Install required shield properly before using the unit.
Page 4
(1) long hex key wrench (1) short hex key wrench (1) bracket cover shield for use with blades shield for use with trimmer head semi-automatic trimmer head shoulder strap with warning brush blade handlebar Examine parts for damage. Do not use dam- aged parts.
Page 5
ATTACHING THE PLASTIC SHIELD AND TRIMMER HEAD WARNING: The shield must be prop- erly installed. The shield provides partial protec- tion from the risk of thrown objects to the opera- tor and others and is equipped with a line limiter which cuts excess line to the proper length.
Page 6
Do not use any blades, or fastening hardware other than the washers and nuts illustrated in the following illustrations. These parts must be provided by Poulan/Weed Eater and installed as shown below. Failure to use proper parts can cause the blade to fly off and seriously hurt you or others.
Gasoline must be mixed with a good quality 2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. Poulan/Weed Eater brand oil is recommended. (A 40:1 ratio is ob- tained by mixing 3.2 ounces of oil with 1 gallon of unleaded gasoline).
The cutting line will last longer and will be less likely to “weld” onto the spool. If the trimmer head does not turn when the en- gine is in operation, make sure the drive shaft housing is properly seated in engine shroud.
Stop engine and blade before removing materials wrapped around blade or tube. REPLACING THE LINE S Press the tab on the side of the trimmer head and twist the lock ring. S Remove the lock ring and tap button. Trimmer...
A metal insert is located in the exit hole. As your unit wears from use, you can re- install this insert upside down to provide a new surface for the exit of the line from the trimmer head. WARNING: When installing the metal insert, you must install from the inside of the trim- mer head.
ELECTROLUX HOME PRODUCTS NORTH AMERICA, Division of WCI Outdoor Prod- ucts, Inc., warrants to the original purchaser that each new Poulan PRO! brand gasoline tool or attachment is free from defects in material and workmanship and agrees to repair or replace un-...
Page 12
POULAN/WEED EATER must warrant the emission control system on your lawn and garden equipment engine for the periods of time listed below provided there has been...