Poulan Pro 530085855 Operator's Manual page 3

Poulan pro trimmer operator's manual
Table of Contents

Advertisement

S Maintain unit according to recommended
procedures. Keep blade sharp. Keep cut-
ting line at the proper length.
S Use only .080" (2 mm) diameter line. Never
use wire, rope, string, etc.
S Install required shield properly before using
the unit. Use the metal shield for all metal
blade use. Use the plastic shield for all line
trimmer use.
S Use only specified blade or trimmer head;
make sure it is properly installed and se-
curely fastened.
S Never start engine with clutch shroud re-
moved. The clutch can fly off and cause se-
rious injury.
S Be sure blade or trimmer head stops turning
when engine idles.
S Disconnect the spark plug before perform-
ing maintenance (except carburetor adjust-
ments).
S Make carburetor adjustments with the lower
end supported to prevent blade or trimmer
line from contacting any object. Hold unit by
hand; do not use the shoulder strap for sup-
port.
S Keep others away when making carburetor
adjustments.
S Use only recommended POULAN PRO ac-
cessories and replacement parts.
S Have all maintenance and service not ex-
plained in this manual performed by your Au-
thorized Service Dealer.
FUEL SAFETY
S Mix and pour fuel outdoors.
S Keep away from sparks or flames.
S Use a container approved for fuel.
S Do not smoke or allow smoking near fuel or
the unit or while using the unit.
S Wipe up all fuel spills before starting engine.
S Move at least 10 feet (3 meters) away from fu-
eling site before starting engine.
S Stop engine and allow it to cool before re-
moving fuel cap.
S Empty the fuel tank before storing the unit.
Use up fuel left in the carburetor by starting
the engine and letting it run until it stops.
S Store unit and fuel in area where fuel vapors
cannot reach sparks or open flames from
water heaters, electric motors or switches,
furnaces, etc.
CUTTING SAFETY
S Inspect the area to be cut before each use.
Remove objects (rocks, broken glass, nails,
wire, string, etc.) which can be thrown or be-
come entangled in the blade or trimmer
head.
S Keep others including children, animals, by-
standers, and helpers at least 50 feet (15 me-
ters) away. Stop engine immediately if you are
approached.
S Always keep engine on the right-hand side
of your body.
S Hold the unit firmly with both hands.
S Keep firm footing and balance. Do not over-
reach.
S Keep blade or trimmer head below waist
level.
S Do not raise engine above your waist.
S Keep all parts of your body away from blade,
trimmer head, and muffler when engine is
running.
S Cut from your right to your left.
S Use only for jobs explained in this manual.
TRANSPORTING AND STORAGE
S Stop the unit before carrying.
S Allow engine to cool and secure unit before
storing or transporting it in a vehicle.
S Empty the fuel tank before storing or trans-
porting the unit. Use up fuel left in the carbu-
retor by starting the engine and letting it run
until it stops.
S Store unit and fuel in an area where fuel va-
pors cannot reach sparks or open flames from
water heaters, electric motors or switches, fur-
naces, etc.
S Store unit so the blade or line limiter cannot
accidentally cause injury. The unit can be
hung by the tube.
S Store unit out of reach of children.
SPECIAL NOTICE:
Exposure to vibrations
through prolonged use of gasoline powered
hand tools could cause blood vessel or nerve
damage in the fingers, hands, and joints of
people prone to circulation disorders or abnor-
mal swellings. Prolonged use in cold weather
has been linked to blood vessel damage in
otherwise healthy people. If symptoms occur
such as numbness, pain, loss of strength,
change in skin color or texture, or loss of feel-
ing in the fingers, hands, or joints, discontinue
the use of this tool and seek medical attention.
An anti-vibration system does not guarantee
the avoidance of these problems. Users who
operate power tools on a continual and regular
basis must monitor closely their physical
condition and the condition of this tool.
SPECIAL NOTICE:
This unit is not
equipped with a temperature limiting muffler
and spark arresting screen which meets the
requirements of California Codes 4442 and
4443. All U.S. forest land and the states of Cal-
ifornia, Idaho, Maine, Minnesota, New Jersey,
Oregon, and Washington require by law that
many internal combustion engines to be
equipped with a spark arrestor screen. If you
operate in a locale where such regulations ex-
ist, you are legally responsible for installing
and maintaining the operating condition of
these parts. Failure to do so is a violation of the
law.
ASSEMBLY
CARTON CONTENTS
Check carton contents for the following:
S
Brushcutter
S
tube mounting screws (2)
S
tube mounting nuts (2)
S
handlebar screws (2)
S
blade shield screws (4)
S
cupped washer (1)
S
large nut for installing blade (1)
S
long hex key wrench (1)
S
short hex key wrench (1)
S
bracket cover
S
shield for use with blades
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pp196

Table of Contents