Adjusting The Handle - Poulan Pro 115249526 Instruction Manual

Poulan pro trimmer/edger instruction manual

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

WARNING:

If received assembled,

repeat all steps to ensure your unit is properly

assembled and all fasteners are secure.

Examine parts for damage. Do not use dam-

aged parts.

NOTE:

If you need assistance or find parts

missing or damaged, call 1-800-554-6723.

It is normal for the fuel filter to rattle in the

empty fuel tank.

Finding fuel or oil residue on muffler is normal

due to carburetor adjustments and testing

done by the manufacturer.

INSTALLING TRIMMER ATTACH-

MENT

CAUTION:

When installing trimmer attach-

ment, place the unit on a flat surface for stability.

1. Loosen the coupler by turning the knob

counterclockwise.

Coupler

Shipping

protector

LOOSEN

TIGHTEN

2. Remove shipping protector from coupler.

3. Remove the shaft cap from the trimmer at-

tachment (if present).

4. Position locking/release button of attach-

ment into guide recess of coupler.

5. Push the attachment into the coupler until

the locking/release button snaps into the

primary hole.

6. Before using the unit, tighten the knob se-

curely by turning clockwise.

Coupler Primary Hole

Guide Recess

Locking/

Upper

Release

Shaft

Button

WARNING:

Make sure the locking/

release button is locked in the primary hole

and the knob is securely tightened before op-

erating the unit. All attachments are designed

to be used in the primary hole unless otherwise

stated in the applicable attachment instruction

manual. Using the wrong hole could lead to seri-

ous injury or damage to the unit.

ASSEMBLY

Locking/Release

Button in Primary Hole

For assembly of optional attachments (see

list on page 11), refer to the ASSEMBLY sec-

tion of the applicable attachment instruction

manual.

ATTACHING THE SHIELD

WARNING:

erly installed. The shield provides partial protec-

tion from the risk of thrown objects to the opera-

tor and others and is equipped with a line limiter

blade which cuts excess line to the proper

length. The line limiter blade (on underside of

shield) is sharp and can cut you. For proper

orientation of shield, see KNOW YOUR TRIM-

MER illustration in OPERATION section.

1. Remove wing nut from shield.

2. Insert bracket into slot as shown.

Knob

3. Pivot shield until bolt passes through hole in

bracket.

4. Securely tighten wing nut onto bolt.

Slot

Shield