Poulan Pro 115156126 Instruction Manual page 17

Poulan pro trimmer/edger instruction manual
Table of Contents

Advertisement

HELPFUL TIP
During storage of your gas/
oil mixture, the oil will sepa-
rate from the gas.
We recommend that you
shake the gas can weekly
to insure proper blending of
the gas and oil.
ENGINE
S Remove spark plug and pour 1 teaspoon of
40:1, 2-cycle engine oil (air cooled) through
the spark plug opening. Slowly pull the
starter rope 8 to 10 times to distribute oil.
TROUBLESHOOTING TABLE
WARNING:
recommended remedies below except remedies that require operation of the unit.
TROUBLE
CAUSE
Engine will not
start.
Engine will
1. Carburetor requires
not idle
properly.
2. Crankshaft seals worn.
3. Compression low.
1. Air filter dirty.
Engine will not
2. Spark plug fouled.
accelerate,
lacks power,
3. Carburetor requires
or dies under
a load.
4. Carbon build-up on
5. Compression low.
Engine
1. Fuel mixture incorrect.
smokes
excessively.
2. Air filter dirty.
3. Carburetor requires
1. Fuel mixture incorrect.
Engine runs
hot.
2. Spark plug incorrect.
3. Carburetor requires
4. Carbon build-up on
Always stop unit and disconnect spark plug before performing all of the
1. Engine flooded.
2. Fuel tank empty.
3. Spark plug not firing.
4. Fuel not reaching
carburetor.
5. Carburetor requires
adjustment.
adjustment.
adjustment.
muffler outlet screen.
adjustment.
adjustment.
muffler outlet screen.
S Replace spark plug with new one of recom-
mended type and heat range.
S Clean air filter.
S Check entire unit for loose screws, nuts,
and bolts. Replace any damaged, broken,
or worn parts.
S At the beginning of the next season, use
only fresh fuel having the proper gasoline to
oil ratio.
OTHER
S Do not store gasoline from one season to
another.
S Replace your gasoline can if it starts to rust.
REMEDY
1. See "Starting a Flooded Engine" in
Operation Section.
2. Fill tank with correct fuel mixture.
3. Install new spark plug.
4. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
5. Contact an authorized service dealer.
1. See "Carburetor Idle Speed Adjustment"
in Service and Adjustments Section.
2. Contact an authorized service dealer.
3. Contact an authorized service dealer.
1. Clean or replace air filter.
2. Clean or replace plug
and regap.
3. Contact an authorized service dealer.
4. Contact an authorized service dealer.
5. Contact an authorized service dealer.
1. Empty fuel tank and refill with
correct fuel mixture.
2. Clean or replace air filter.
3. Contact an authorized service dealer.
1. See "Fueling Engine" in Operation
section.
2. Replace with correct spark plug.
3. Contact an authorized service dealer.
4. Contact an authorized service dealer.
17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pp330

Table of Contents