Kenwood KDC-320UI Instruction Manual page 33

INSTALLATION/CONNECTION
Part list for installation
(A) Faceplate
(C) Mounting sleeve
(E) Extraction key
Basic procedure
1 Remove the key from the ignition switch, then disconnect the
[ terminal of the car battery.
2 Connect the wires properly.
See Wiring connection. ( 30)
3 Install the unit to your car.
See Installing the unit (in-dash mounting).
4 Connect the [ terminal of the car battery.
5 Press
to turn on the power.
6 Detach the faceplate and reset the unit within 5 seconds. ( 3)
(B) Trim plate
(D) Wiring harness
Installing the unit (in-dash mounting)
Hook on the top side
Orientate the trim plate as
illustrated before fitting.
How to remove the unit
1 Detach the faceplate.
2 Fit the catch pin on the extraction keys into
the holes on both sides of the trim plate,
then pull it out.
3 Insert the extraction keys deeply into the
slots on each side, then follow the arrows as
shown on the illustration.
Do the required wiring.
( 30)
Dashboard of
your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
29
ENGLISH