Configuration Examples For Sgac; Example: Sgac Configuration Commands - Cisco cBR 8 Configuration Manual

Configuration Examples for SGAC

Step 3
Step 4
Step 5
What to Do Next
Use the show cable admission-control fiber-node n command to verify admission-control configuration.

Configuration Examples for SGAC

This section describes solutions-level examples of the SGAC feature on the Cisco CMTS. This section
illustrates the functioning of SGAC in default or non-default operational configurations.

Example: SGAC Configuration Commands

In this section of configuration examples, the following SGAC parameters are set on the Cisco CMTS:
• All the packetcable flows are mapped into bucket 1.
• The BE service flows are mapped into bucket 8.
The following configuration commands enable these settings:
• To map the packetcable voice flows, use:
cable application-type 1 include packetcable normal
cable application-type 1 include packetcable priority
cable application-type 1 name PktCable
• To map the BE flows into bucket 8, use:
cable application-type 8 name HSD
cable application-type 8 include best-effort
Cisco cBR Series Converged Broadband Routers Quality of Services Configuration Guide for Cisco IOS XE
Fuji 16.7.x
112
Command or Action
cable fiber-node id
Example:
Router(config)# cable fiber-node 1
admission-control application-type n
ds-bandwidth pct
Example:
Router(config-fiber-node)#
admission-control application-type 1
ds-bandwidth 1
Ctrl-Z
Example:
Router(config-if)# Ctrl^Z
Service Group Admission Control
Purpose
Enters cable fiber-node configuration mode to
configure a fiber node.
Enables SGAC checking for the specified
application-type.
Use the no form of this command to disable
SGAC checking.
Returns to Privileged EXEC mode.