Haier HW70-12829 User Manual page 23

GB
Problem Cause
• Motor - error.
F7
FC0, FC1 or • Abnormal communication error.
FC2
• Unbalanced load - error.
UNB
9.3 Troubleshooting without display code
Problem
Washing machine fails
to operate.
Washing machine
will not be filled with
water.
Machine is draining
while being filled.
Drainage failure.
Strong vibration while
spinning.
Operation stops
before completing
wash cycle.
Operation stops for
a period of time.
Excessive foam floats
drum and/or deter-
gent drawer.
Cause
• Programme is not yet started.
• Door is not properly closed.
• Machine has not been switched on.
• Power failure.
• Child lock is activated.
• No water.
• Inlet hose is kinked.
• Inlet hose filter is blocked.
• Water pressure is less than 0.03 MPa.
• Door is not properly closed.
• Water supply failure.
• Height of drain hose is below 80 cm.
• Drain hose end could reach into
water.
• Drain hose is blocked.
• Pump filter is blocked.
• Drain hose end is higher than 100 cm
above floor level.
• Not all transportation bolts have
been removed.
• Appliance has no solid position.
• Machine load is not correct.
• Water or electric failure.
• Appliance displays error code.
• Problem due to load pattern.
• Programme performs soaking cycle.
• Detergent is not a appropriate.
• Excessive use of detergent.
9-Troubleshooting
Solution
• Contact the After sales service.
• Contact the After sales service.
• Check and balance laundry load in the drum.
Reduce the load.
Solution
• Check programme and start it.
• Close the door properly.
• Switch the machine on.
• Check power supply.
• Deactivate child lock.
• Check water tap.
• Check inlet hose.
• Unblock inlet hose filter.
• Check water pressure.
• Close the door properly.
• Ensure the water supply.
• Make sure that drain hose is
properly installed.
• Make sure the drain hose is not
in water.
• Unblock drain hose.
• Clean pump filter.
• Make sure that drain hose is
properly installed.
• Remove all transportation bolts.
• Ensure solid ground and a levelled
position.
• Check load weight and balance.
• Check power and water supply.
• Consider display codes.
• Reduce or adjust load.
• Cancel programme and restart.
• Check detergent recommen-
dations.
• Reduce amount of detergent.
23