Table of Contents
Advertisement
CONFIGURING THE MPS-488HP IN COMPASS
To configure the MPS-488HP in Compass Control Software:
1. Power on the MPS-488HP and RMServer(s).
2. Connect Compass and RMServer to the same local area
network (LAN).
3. In Compass, click the RMServer > Inventory tab.
4. In the Device list, right-click the MPS-488HP powering
the Ashby speakers and choose Edit Loudspeaker
Inventory.
5. In the Edit Loudspeaker Inventory dialog box, click in the
Product column and select the Ashby loudspeaker model
connected to each MPS-488HP channel output.
Figure 5: Edit Loudspeaker Inventory dialog in Compass
6. Enter a name and the number of speakers looped on each
channel.
7. Click OK to save and upload the MPS-488HP loud-
speaker inventory.
Once the MPS-488HP is added to an RMS page, the
device container can display channel labels with simple
device status or a full meter bar display along with a
detailed text view showing voltage and current draw for
the connected Ashby loudspeakers.
Figure 6: Voltage and current draw for connected speakers in Compass
CAUTION:
Disconnect the mains plug or power
off the MPS-488HP before disconnecting its
power cord.
ASHBY OPERATING INSTRUCTIONS
11
Advertisement
Table of Contents
