Notes - Genie LM-215 User Manual

Notes

 Please put the facility in flat, stable and draughty place and avoid direct sunlight, high
temperature, humidity, dust and corrosive gas.
 If the product is installed on the wall, please make sure the wall's load bearing is enough. To
avoid falling and hurt people, install according to the illustration.
 The LCD might get nebulized when the temperature variation is big, which will cause image
distortion or decay of color. Wait for a moment (with power on) and the nebulization will
disappear.
 Do not block up the ventilation opening. Install the facility according to this handbook.
 Do not install the facility near any heat source such as radiator, heat register or stove.
 Do not use unqualified connecting lines, which might cause equipment failure.
 Do not press, stretch or heat the connecting line, which might cause damage to it.
 Please firmly grasp the plug of the connecting line when inserting and drawing. Pulling the
connecting line emphatically might cause damage to it.
 Cut off power and the connecting line immediately and contact the after-sales service
center if the facility or the connecting line is damaged for some reason. Continuing using
without maintaining might cause smoking or off-flavor.
 Do not hang or shin on the facility, which might cause the facility to fall, upset or damaged
and cause hurt to people. Be more careful when there are kids near the facility.
 Please cut off power for safety if not using the facility for a long time.
 Do not let the connecting line get squeezed by the wall or buckle, pull or twine the
connecting line overly.
 Make sure the power and the connecting line are cut off when moving the facility.
 Keep the facility from getting collided, which might cause equipment failure.
User Manual
3