Toshiba AW-SD150SBA Service Manual page 51

Unless otherwise specified, reassembling is to be performed in the reverse procedures of disassembling.
Part Name Illustration
(10) Lead wire
assembly
Repair Procedures Description in
8
Remove the rear cover. (6 screws)
9
Remove the lead wire clamps (1 places) from the
external case. Then remove the lead wire bundle from
the cord holder (by takeoff 1 screw).
(Photo 35)
10
Remove the tapping screws (2 pcs) on the back side
of top cover.
(Photo 36)
11
Remove the circle sheet side of the top cover(2 pc)
with a flat tip screw-driver. Remove the screw(2 pc)
under the circle sheet.
12
Pull up the top cover from cabinet.
(Photo 37)
13
Let the whole top cover lean against the wall, etc. to
let it stand on the external case.
At this time, put a towel between the lead wire and
external case to prevent lead wires from being cut. In
addition, put a towel on the air tube of the water level
sensor to prevent it from being damaged with the top
end of the external case. Pay attention not to deform
the safety lever.
(Photo 38)
14
&uW WKH lHDG FODPSV  SFV from the top cover.
15
Remove the lead wire assy from the hooN of the top
cover. Take out the lead wire assy from the top cover.
16
Let the whole lead wire assy down on the external
case.
17
Remove the taping bundling the lead wires. Then
separate the lead wires (lead wires in the top cover
and lead wire connectors on the main unit side).
(Photo 39)
–  –
shows notes.
(Photo 35)
(Photo 36)
(Photo 37)
(Photo 38)
(Photo 39)