About Static Rinse Mode; “Static Rinse” Mode - Toshiba AW-SD150SBA Service Manual

About Static Rinse Mode

1. "Static rinse" mode
There is a mode to change from "shower rinse" to "static rinse" mode by invisible button operation.
Use this mode for users who have a problem in "white rinsing water" or those who want longer rinsing.
(1) Applicable course
Concentrated standard, standard, soak and memory
(2) Mode setting method
1 of shower rinse becomes 1 of static rinse.
Rinse cycle becomes same as the case where bath water is used until rinse process.
Press the power button, then
Press for 3 seconds.
• The setting method for the past models, i.e., turn on the power while pressing "RINSE" + "COURSE"
can also be used.
(3) Rinse cycle
"Shower rinse" becomes "Static rinse" as shown in the table below.
Display
1 rinse
1 rinse +
overflow rinse
2 rinse Shower
2 rinse + Shower
overflow rinse
3 rinse Shower Shower
3 rinse + Shower Shower
overflow rinse
4 rinse Shower Shower
4 rinse + Shower Shower
overflow rinse
One-Point Information
1
Turn on the power.
2
Press
in approximately 5 seconds when the buzzer beeps.
Turn off the power.
• To return to shower rinse mode, perform the above
operation again. When the setting to shower rinse
completes, the buzzer beeps.
• Once the setting is made, it will be stored in the memory.
Rinse Cycle
Static
overflow
Static
overflow
Static
overflow
Static
Static
overflow overflow
– 16 –
button for 3 seconds. The setting completes
Static Rinse Cycle
Static
Static
Static Static
Static
Static
Static
Static
Static
Static
Static
overflow
Static
overflow
Static
overflow
Static Static
overflow overflow