Hot Water Connection; Drain Connection; Water Supply Connection - Bosch SHEM78WH5N Operating Instructions Manual

en-us Installation and connection
Installation
The required installation dimensions
can be found in the installation
instructions. Level the appliance with
the aid of the height-adjustable feet.
Ensure that the appliance is situated
securely on the floor.
A built-under or integrated
■
appliance which is installed
subsequently as a free-standing
appliance must be secured to
prevent it from overturning, e.g. by
screwing it to the wall or by
installing it under a continuous
worktop which is screwed to
adjacent cupboards.
The appliance can easily be
■
installed in a fitted kitchen
between wooden and plastic
walls.

Drain connection

1. The required work sequence can
be found in the installation
instructions. If required, fit
a siphon with a drain connection.
2. Connect the drain hose
to the drain
connection of the siphon with
the enclosed parts.
Ensure that the drain hose is not
kinked, crushed or twisted
and that there is no cover
plate in the drainage to prevent
the drain water from flowing out!

Water supply connection

1. Fasten the water supply
connection to the tap according
to the installation instructions
using the enclosed parts.
Ensure that the water supply
connection is not kinked, crushed
or twisted.
2. When replacing the appliance,
always use a new water supply
hose.
60
Water pressure:
At least 0.05 MPa (0.5 bar),
maximum 1 MPa (10 bar).
At a higher water pressure:
connect pressure-reducing valve
ahead.
Inlet rate:
Minimum 10 litres/minute
Water temperature:
Cold water.
Hot water:
Maximum temperature 140° F
(60 °C).

Hot water connection *

The dishwasher can be connected
to cold or hot water up to max.
140° F (60 °C). Connection to hot
water is recommended if the hot
water can be supplied by
energetically favourable means and
from a suitable installation, e.g. solar
heating system with circulation line.
This will save energy and time. The
"Hot water" setting allows you to
adjust your dishwasher optimally to
operation with hot water. It is
recommended to have a water
temperature (temperature of the
incoming water) of at least 104° F
(40 °C) and no more than 140° F
(60 °C). It is not recommended to
connect the appliance to hot water if
the water is supplied from an electric
boiler.