Drinking Water Connection; Hot Water Connection - Bosch SM SERIES Instruction Manual

Drinking water connection

Fasten the drinking water connection
1.
to the tap according
to the installation instructions using
the enclosed parts.
Ensure that the drinking water
connection is not kinked, crushed
or twisted.
When replacing the appliance,
2.
always use a new water supply
hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum 1
MPa (10 bar).
At a higher water pressure:
connect pressure-reducing valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water.
Hot water:
Maximum temperature 60 °C.
Installation and connection en

Hot water connection *

* depending on the features of your
i o n H o t w a t e r c o n n e c t
dishwasher
The dishwasher can be connected to
cold or hot water up to max. 60°C.
Connection to hot water is
recommended if the hot water can be
supplied by energetically favourable
means and from a suitable installation,
e.g. solar heating system with
circulation line. This will save energy
and time. The "Hot water" setting allows
you to adjust your dishwasher optimally
to operate with hot water. It is
recommended to have a water
temperature (temperature of the
incoming water) of at least 40 °C and
no more than 60 °C. It is not
recommended to connect the appliance
to hot water if the water is supplied from
an electric boiler.
Here's how to change the hot water
setting:
Switch on ON/OFF switch (.
1.
Press and hold the ‹ button
2.
for 3 seconds.
The value •:‹... and ' will appear in
the display window @.
Press the ‹ button repeatedly
3.
until the factory setting value ':‹‹
appears in the display window @.
Adjust the setting using the buttons
4.
+ and - H.
Press and hold the ‹ button
5.
for 3 seconds.
The chosen setting has now been
stored in your dishwasher.
47