Installation; Windshield Mounting - Cobra SPX955 Operating Instructions Manual

Installation

Your Detector
Installation
Where to Mount Your Unit
You will get optimum performance from your detector if you Mount it at a
point approximately in the center of the vehicle, as low as possible on the front
windshield without obstructing the unit's view of the road either to
the front or rear. Make sure the unit is level with the road. You can also
mount it directly on the dashboard.

Windshield Mounting

The unit's lens must not be blocked and the LaserEye should have a clear view
out the back window to allow 360° detection.
The LaserEye Should Have a Clear View
Radar and laser
signals pass
through glass but
not through other
materials and
objects. Objects
that can block or
weaken incoming signals include:
Windshield wiper blades
g
Mirrored sun screens
g
Dark tinting at the top of the windshield
g
Heated windshields currently available on some vehicles
g
(Instaclear for Ford, Electriclear for GM.) Consult your dealer
to see if you have this option.
English
2
SPX955_MANL.indd 2-3
•
Dashboard Mounting
Installation
Your Detector
Windshield Mounting
1.
Attach the rubber
cups to the bracket.
2. Make sure the rubber cups and your windshield are clean.
3. Push the bracket firmly onto
the windshield.
4. Attach the detector to
the bracket. Check the
angle of the unit.
5. To adjust the angle if
necessary, gently push or
pull on the bracket to bend
it. DO NOT use the detector
to bend the bracket.
6. Plug the power cord
into the detector.
7. Plug the cigarette lighter
adapter on the power
cord into your vehicle's
cigarette lighter.
8. You can temporarily remove the detector whenever you
wish by pressing the bracket release button and sliding
it off the bracket.
Nothing Comes Close to a Cobra
3
®
4/10/15 2:05 PM