Example For Configuring Intra-Vlan Proxy Arp - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
arp-proxy enable
#
interface Vlanif3
ip address 172.16.2.1 255.255.255.0
arp-proxy enable
#
interface GigabitEthernet1/0/0
port link-type access
port default vlan 2
#
interface GigabitEthernet1/0/1
port link-type access
port default vlan 3
#
return

2.11.3 Example for Configuring Intra-VLAN Proxy ARP

Networking Requirements
As shown in
VLAN 2 belong to super-VLAN 3. It is required that:
l
l
The IP address and subnet mask of the VLANIF interface in super-VLAN 3 should be 10.10.10.1
and 255.255.255.0.
Figure 2-5 Networking diagram for configuring intra-VLAN proxy ARP
00-e0-fc-00-00-03
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Issue 01 (2012-03-15)
Figure 2-5, GE 1/0/1 and GE 1/0/0 of the Switch belong to sub-VLAN 2. Sub-
Host A and host B in VLAN 2 should be isolated at Layer 2.
Host A should communicate with host B at Layer 3 through intra-VLAN proxy ARP.
Internet
GE1/0/1
hostB
10.10.10.3/24
sub-VLAN2
Create and configure a super-VLAN and a sub-VLAN.
Add an interface to the sub-VLAN.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Switch
GE1/0/0
hostA
10.10.10.2/24
00-e0-fc-00-00-02
2 ARP Configuration
37