S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
2.3.1 Establishing the Configuration Task
This section describes the applicable environment, pre-configuration tasks, data preparation, and
configuration procedure for configuring static ARP.
Applicable Environment
Static ARP is used in the following situations:
l
l
Pre-configuration Tasks
Before configuring ARP, complete the following tasks:
l
l
Data Preparation
To configure ARP, you need the following data.
No.
1
2
2.3.2 Configuring Common Static ARP Entries
Static ARP entries are required for the communication between common interfaces.
Context
If static ARP and the Virtual Router Redundancy Protocol (VRRP) are enabled on a device
simultaneously, the virtual IP address of the VRRP backup group configured on the VLANIF
interface cannot be the IP address contained in the static ARP entries; otherwise, incorrect host
routes are generated and thus packets cannot be normally forwarded.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Issue 01 (2012-03-15)
For the packets whose destination IP address is on another network segment, static ARP
can help these packets traverse a gateway of the local network segment so that the gateway
can forward the packets to their destination.
When you need to filter out some packets with illegitimate destination IP addresses, static
ARP can bind these illegitimate addresses to a nonexistent MAC address.
Configuring link layer protocol parameters for the interface and ensuring that the status of
the link layer protocol on the interface is Up
Configuring the network layer protocol for the interface
Data
IP address and MAC address of the static ARP entry
VPN instance name and VLAN ID to which the static ARP entry belongs
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 ARP Configuration
17