Table of Contents
Advertisement
You can:
•
Customize the firewall configuration
•
Add and configure IPSec, PPTP, and L2TP VPNs
•
Configure the Network Intrusion Detection (NIDS)
•
Customize virus and worm protection
•
Configure logging and reporting
•
Customize the DFL-1000 system configuration
Configuring the DMZ interface
Use the following procedure to change the IP address of the DMZ interface. Using the web- based
manager:
•
Go to System > Network > Interface.
•
For the dmz interface, select Modify
•
Change IP address and netmask as required.
•
Select Apply.
Transparent mode
This Quick Install Guide describes how to configure the DFL-1000 to run in Network Address
Translation (NAT) mode. You can also configure the DFL-1000 to run in Transparent mode. Refer to
the Transparent mode installation chapter of the DFL-1000 User Manual.
10. Troubleshooting
Reconnecting to the web- based manager
If you changed the IP address of the internal interface, you must reconnect to the web- based
manager by browsing to https:// followed by the new IP address. You may also have to change the
IP address of the management computer to be on the same subnet as the internal interface.
.
Advertisement
Table of Contents
