Table of Contents
Advertisement
3. Start Internet Explorer version 4.0 or higher. Type https://192.168.1.99 into the Address field
and press Enter.
Your browser connects to the web- based manager and the DFL-1000 login page appears.
4. Type admin in the Name field and select Login.
5. Select the Wizard button at the upper right of the web- based manager to start the setup
wizard.
6. Use the information you gathered on the first two pages of this Quick Install Guide to fill in the
wizard fields as required. Select next to step through the wizard pages.
7. Confirm your configuration settings and then select Finish and Close.
You are ready to connect the DFL-1000 to your network.
7. Basic configuration using the CLI
As an alternative to the setup wizard, you can use the command line interface (CLI) to configure the
DFL-1000.
To use the CLI:
1. Connect one end of the null-modem cable to the DFL-1000 Console (RS-232 serial)
connector and connect the other end to a serial port of a management computer or terminal.
2. On the management computer, start a terminal program such as HyperTerminal.
3. Set the Baud Rate (bps) to 9600, Data bits to 8, Parity to None, Stop bits to 1, and flow control
to None.
4. Press Enter to connect to the DFL-1000.
Advertisement
Table of Contents
