Vertex Standard VX-264 Operating Manual page 25

s s
can et
Press, (or press and hold), the assigned PF key to add/de-
lete the current channel to/from your scanning list.
To store a particular channel to your scanning list, press, (or
press and hold), the assigned PF key. If you delete a chan-
nel from your scanning list, press, (or press and hold), the
assigned PF key again.
When the scanner is paused, you may remove the channel
from the scan list temporarily by pressing, (or press and
holding), the same key.
Note 1: when store a particular channel to your scanning
list, the display indicates "Scan.Set" briefly and "
will appear on the display.
Note 2: when delete a channel from your scanning list, the
display indicates "Scan. Skip" briefly and the "
will disappear from the display.
VX-264 O M
perating anual
a o
dVanced Peration
g
rouP
You may wish to have the Scanner pass through more than
one Group during the scanning process (normally, scan-
ning is performed within the current group only).
To include the current Group in the scanning loop, press,
(or press and hold), the assigned PF key. To remove a cur-
rent Group from Group Scan, press, (or press and hold),
the assigned PF key again.
ta ( t
Press, (or press and hold), the assigned PF key to toggle
the TA Scan feature "On" and "Off".
While TA Scan is proceeding, the transceiver will search
" icon
both the transmit and receive frequencies. When a signal
is encountered on the receive frequency, the transceiver
" icon will pause until the signal disappears. When a signal is
encountered on the transmit frequency, the transceiver
will check for activity on the receive frequency every few
seconds (interval programmed by your Vertex Standard
dealer).
When the TA Scan feature is activated, the "
be blinked on the display.
Note: The TA Scan feature does not activate on the Sim-
plex Channel.
s s
can et
) s
a
alK round can
FCC ID: AXI11273020
IC: 10239A-11273020
" icon will
23
Vertex Standard LMR, Inc.