Vertex Standard VX-264 Operating Manual page 15

r Rotate the VOL/PWR
knob to set the volume
level. If no signal is pres-
ent on the analog chan-
nel, press (or press and
hold) the Programmable
k e y ( a s s i g n e d t o t h e
"sql oFF" function:
Normally SIDE-1 but-
ton); background noise
will now be heard, and
you may use this to set
the VOL/PWR knob for
the desired audio level.
Press (or press and hold) the Programmable key again to
quiet the noise and resume normal (quiet) monitoring.
r To transmit, monitor the
channel and make sure it
is clear.
Press and hold the PTT
switch. Speak into the
microphone area of the
front panel grille in a
normal voice level. To return to the Receive mode, re-
lease the PTT switch.
VX-264 O M
perating anual
o
Peration
r Press (or press and hold)
the ,S ID E -1 S ID E -2
button, or front panel's
programmable keypad
([ A ] - [ D ] key ) to ac-
tivate one of the pre-
programmed functions
which may have been
enabled at the time of
p r o g r a m m i n g b y t h e
d e a l e r. S e e t h e n e x t
chapter for details re-
garding feature availabil-
ity for this radio.
r If a Speaker/Microphone
is available, remove the
plastic cap and its two
mounting screws from
t h e r i g h t s i d e o f t h e
transceiver, then align
t h e c o n n e c t o r o f t h e
Speaker/Microphone on
the radio; secure the con-
nector pin using the screws supplied with the Speaker/
Microphone. Hold the speaker grille up next to your
ear while receiving. To transmit, press the PTT switch
FCC ID: AXI11273020
IC: 10239A-11273020
13
Vertex Standard LMR, Inc.