Troubleshooting - Kenwood KMM-BT522HD Instruction Manual

DISPLAY SETTINGS
DISPLAY
COLOR Select color for ALL ZONE, ZONE 1 and ZONE 2 separately.
SELECT * 1
1 Select a zone. (See the illustration on page 28.)
2 Select a color for the selected zone.
INITIAL COLOR/VARIABLE SCAN/CUSTOM R/G/B/preset colors *
Default:
VARIABLE SCAN
To make your own color, select [CUSTOM R/G/B]. The color you have made
will be stored in [CUSTOM R/G/B].
1 Press the volume knob to enter the detailed color adjustment.
2 Press S / T to select the color (R/G/B) to adjust.
3 Turn the volume knob to adjust the level (0 to 9), then press the knob.
DIMMER Dim the illumination.
ON: Dimmer is turned on. ; OFF: Cancels.
DIMMER TIME: Set the dimmer on and off time.
1 Turn the volume knob to adjust the [ON] time, then press the knob.
2 Turn the volume knob to adjust the [OFF] time, then press the knob.
(Default: [ON]: PM6:00 or 6:00PM; [OFF]: AM6:00 or 6:00AM)
BRIGHTNESS 1 Select a zone. (See the illustration on page 28.)
2 0 to 31: Select your preferred brightness level for the selected zone.
TEXT SCROLL AUTO/ONCE: Select whether to scroll the display information automatically,
or scroll only once. ; OFF: Cancels.
* 1
For /
* 2
Preset colors: RED1/RED2/RED3/PURPLE1/PURPLE2/PURPLE3/PURPLE4/BLUE1/
BLUE2/BLUE3/SKYBLUE1/SKYBLUE2/LIGHTBLUE/AQUA1/AQUA2/GREEN1/
GREEN2/GREEN3/YELLOWGREEN1/YELLOWGREEN2/YELLOW/ORANGE1/ORANGE2/
ORANGERED
Default: XX
/ /
: INITIAL COLOR
/ /

TROUBLESHOOTING

Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
2
:
"PROTECTING SEND SERVICE"
appears.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
display is incorrect.
The unit does not work at all. Reset the unit. ( 3)
(For
"SET ERROR"/"DEL ERROR"
• Radio reception is poor.
• Static noise while listening
to the radio.
"READING" keeps flashing.
Elapsed playing time is not
correct.
"LOADING" appears when
you enter search mode by
pressing .
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the
terminals of the speaker wires are insulated properly.
Turn the power on again.
Send the unit to the nearest service center.
Clean the connectors. ( 32)
) Setting/deleting the remote control ID is unsuccessful.
Turn the power off, then turn on the power and
perform the operation again. ( 5)
Connect the antenna firmly.
Do not use too many hierarchical levels or folders.
This is caused by how the tracks are recorded.
This unit is still preparing the iPod/iPhone music list.
It may take some time to load, try again later.
29
ENGLISH