Installing The Ap; Determining The Installation Site; Mounting The Ap On A Wall - 3Com WL-607 Quick Installation Manual

Appendix C Installing the AP
Note:
1) Make sure that no metal particles (such as screws) fall into the Ethernet or
console interfaces during installation.
2) Before installing the AP9152 to the wall-mounting bracket, connect the
network cable. The network cable can only be UTP cat-5.
3) Before connecting the console cable to the AP9152 for debugging or
pressing the reset button, you need to remove the device from the
wall-mounting bracket.

Determining the Installation Site

Determine the installation site by observing the following principles:
Install the AP in an area away from obstacles that can cause
interference.
Keep the AP far away from electronic devices (such as microwave
ovens) that may generate RF noise.
Ensure that the installation site will not cause any inconvenience or
nuisance.
Note:
1) Make sure the ceiling is strong enough and the structure is suitable in case of
ceiling mounting. Reinforce the ceiling if needed.
2) Us a Kensington lock if physical security is required to protect the AP from
being stolen.

Installing the AP

The AP9152 support three installation methods:

Mounting the AP on a wall

Mounting the AP on a ceiling
Mounting the AP to a T-rail
Mounting the AP on a Wall
The following describes how to mount an AP9152 on a wall:
Installing the wall-mounting bracket on the wall
Installing the AP on the wall-mounting bracket
Locking the AP onto the wall-mounting bracket (optional)
Installing the wall-mounting bracket on the wall
iv