Installing Wire Guides And Drive Rolls - Miller Continuum Owner's Manual

5-13. Installing Wire Guides And Drive Rolls

8
7
9
10
Installing Wire Guide And Drive Rolls
1 Drive Roll Tension Assembly
Open tension assembly.
2 Drive Roll Bracket Screw
3 Drive Roll Bracket
4 Drive Roll Carrier And Securing Ring
Remove bracket screw.
Remove drive roll bracket.
5 Drive Roll
Rotate securing rings until tabs line up with
grooves in drive rolls. Remove drive rolls
from carriers.
6 Ball And Spring Assembly
7 Anti-Wear Guide
8 Inlet Wire Guide
OM-266409 Page 22
6
2
9 Thumb Screw
Install inlet wire guide into anti-wear guide,
and secure with setscrew.
Loosen thumb screw.
Push inlet guide into opening until groove
aligns with thumb screw. Tighten thumb
screw to secure inlet guide.
10 Intermediate Wire Guide
.
Shoulder on intermediate wire guide
faces to rear of drive housing.
Push intermediate guide into opening until
groove is secured by ball and spring
assembly.
Install drive rolls and drive roll bracket.
Secure bracket with screw.
11 Upper Drive Roll Shaft
1
11
5
4
3
Pull drive roll shaft and remove drive roll
carrier. Install drive roll, rotate securing ring
until it stops at a detent position, place car-
rier back into tension assembly bracket,
and secure carrier with drive roll shaft. Do
the same for the remaining tension
assembly.
.
Never close Tension Assembly if Drive
Roll Bracket (3) is removed.
Aligning Wire Guide And Drive Rolls
Self-aligning drive rolls do not require any
manual adjustment.
Cleaning Drive Rolls
Remove drive rolls, and clean grooves
using a wire brush.
Close drive assembly cover.
Ref. 260233-B / Ref. 269 820-A