Marksman 67063c Instruction Manual page 7

600w angle grinder 230v~50hz 11000rpm 115mm disc
Table of Contents

Advertisement

and adjusting wrenches are removed from tool before turning it on.
16. Avoid unintentional starting
switch is off when plugging in.
17. Outdoor use extension cords
intended for use outdoors and so marked.
18. Stay alert
- Watch what you are doing, Use common sense. Do not operate tool when you
are tired.
19. Check damaged parts
damaged should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment of moving parts, binding of moving parts, breakage of
parts, mounting, and any other conditions that may affect its operation.
- A guard or other part that is damaged should be properly repaired or replaced by an
authorised service centre unless otherwise indicated elsewhere in this instruction manual.
Have defective switches replaced by an authorised service centre. Do not use tool if switch
does not turn it on and off.
20. Warning
- The use of any other accessory or attachment other than that recommended in this
operating instruction might present a risk of personal injury.
21. Have your tool repaired by an expert
relevant safety rules. Only experts may carry out repairing of electric appliances otherwise it
may cause considerable danger for the user.
22. connect the dust extraction device
extraction system, make sure it is connected and used.
23. Noise level
- The noise level of this power tool is measured according to IEC 59 co 11, IEC
704, DIN 45635 Part 21, NFS 31081 (84/537IEWG). Noise level at work area can exceed 85 dB
(A). In that case operators should protect themselves against damage to hearing - wear ear
defenders.
WARNING:
THIS PRODUCT OPERATES AT 230 VOLT AC SINGLE PHASE MAINS VOLTAGE.
READ ALL THE SAFETY INSTRUCTIONS BEFORE USING THE MACHINERY.
OBSERVE ALL THE LOCAL SAFETY REGULATIONS.
This product Is "CE" marked and complies with all the relevant European CE directives for LVD,
EMC and Machinery safety.
- Don't Carry plugged-in tool with finger on switch. Be sure
- When tool is used outdoors, use only extension cords
- Before further use of the tool, a guard or other part that is
- This electric appliance is in accordance with the
- Wherever there are facilities for fitting a dust

Advertisement

Table of Contents
loading

This manual is also suitable for:

67071c

Table of Contents