Table of Contents
Advertisement
Unpacking Oven
•
Inspect oven for damage such as dents in door or inside oven cavity.
•
Report any dents or breakage to source of purchase immediately.
Do not attempt to use oven if damage.
•
Remove all materials from oven interior.
•
If oven has been stored in extremely cold area, wait a few hours before
connecting power.
Radio Interference
•
Operation of the microwave oven may cause interference to your radio, TV
or similar equipment.
•
When there is interference, it may be reduced or eliminated by taking the
following measures:
1) Clean door and sealing surface of the oven
2) Reorient the receiving antenna of radio or television.
3) Relocate the microwave oven with respect to the receiver.
4) Move the microwave oven away from the receiver.
5) Plug the microwave oven into a different outlet so that microwave oven
and receiver are on different branch circuits.
Oven Placement
•
Do not install oven next to or above source of heat, such as pizza oven or
deep fat fryer. This could cause microwave oven to operate improperly and
could shorten life of electrical parts.
•
Do not block or obstruct oven filter. Allow access for cleaning.
•
Install oven on level countertop surface.
•
Place warning label in a conspicuous place close to microwave oven.
•
Outlet should be located so that plug is accessible when oven is in place.
The switching operation of this microwave oven can cause voltage fluctuations
on the supply line. The operation of this oven under unfavorable voltage
supply conditions can have adverse effects. This device is intended system
impedance Zmax of 0.26 Ohm at the interface point of the user's supply. The
user has to ensure that this device is connected only to a power supply
system which fulfills the requirement above. If necessary, the user can ask the
public power supply company for the system impedance at the interface point.
5
Installation
Grounding Instructions
This appliance must be grounded. In
the event of an electrical short circuit,
grounding reduces the risk of electric
shock by providing an escape wire for
the electric current. This appliance is
equipped with a cord having outlet that
a grounding plug. The plug must be
plugged into an outlet that is properly
installed and grounded.
WARNING
- Improper use of the
grounding can result in a risk of electric
shock.
Consult a qualified electrician or
serviceman if the grounding
instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded, and either:
(1) If it is necessary to use an
extension cord, use only a 3-wire
extension cord that has a 3-blade
grounded plug, and 3-slot
receptacle that will accept the plug
on the appliance. The marked
rating of the extension cord shall be
equal to or greater than the
electrical rating of the appliance,
or
(2) Do not use extension cord. If the
power supply cord is too short,
have a qualified electrician or
service man install an outlet near
the appliance.
Advertisement
Table of Contents
