JRC JUE-87 Instruction Manual page 83

INFORMATION message
Now printing. Please wait.
Now reading data. Please wait
Really quit without saving? [Yes] [No]
The attached USB drive has malfunctioned, and DTE does
not recognize the attached USB drive.
The attached USB drive is not supported. DTE supports
the USB drive only.
The USB drive can now be safety removed from DTE.
The USB drive is installed and ready to use.
The USB drive was removed before the USB drive is
stopped.
There is a possibility of the USB IC failure. All USB
functions are disabled.
To stop the USB drive, choose Yes. After the USB drive is
stopped the USB drive can be safety removed.
[Yes] [No]
Tune to NCS (144) cancelled.
Tune to NCS (144) failed.
When the display doesn't disappear, the
breakdown of the printer is thought. In
this case, please OFF/ON it the power
supply of the printer.
Do not remove a diskette during data
reading.
Select [Yes] to save the data.
Connect the USB drive again. If the same
window is displayed, the USB drive
might have a failure. Connect another
USB drive.
Connect the USB drive again. If the same
window is displayed, the USB IC in the
DTE might have a failure.
Confirm whether there is a shield between
the antenna and the satellite.
Carry out NCS scanning again.
4-17
Countermeasure
4