Table of Contents
Advertisement
The transmitter will learn and transmit the frequencies
of
most current transmitters and is powered by your
vehicle's battery and charging system.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Programming the Transmitter
Do not use the transmitter with any garage door opener
that does
not have the "stop and reverse" feature. This
includes any garage door opener model manufactured
before April I , 1982.
Be
sctre that
people and objects ure clear o f the garuge
door you are progrmnmin.g!
Your vehicle's engine should be turned off while
programming the transmitter. Follow these steps to
program up to three channels:
1.
2.
3.
If you have not previously programmed a universal
channel, proceed to Step 2. Otherwise, hold
down the two outside buttons on the universal
transmitter until the red light begins to flash rapidly
(approximately 20 seconds). Then release the
buttons. This procedure initializes the memory and
erases any previous settings for all three channels.
Hold the end of the hand-held transmitter against the
bottom surfixe of the universal transmitter so that
you can still see the red light.
Decide which one of the three channels you want to
program. Using both hands, press the hand-held
transmitter button and the desired button on the
universal transmitter. Continue to hold both buttons
through Step 4.
Advertisement
Table of Contents
