Underhood Lamp - Oldsmobile bravada 1996 Owner's Manual

Taillamps
1. Open the endgate.
2. Remove the'two screws
from the lamp. assembly.
I
3. 'Pull the assembly away from the vehicle.
4. Turn the socket counterclockwise to remove
it.
Push
the tab in while you turn the s,cjcket counterclockwise.
5. Holding the base of the bulb, pull the bulb straight
out of the socket.
, -
6.
7.
8.
9.
Push the new bulb straight into the socket until
it clicks.
Put the socket into the lamp assembly and
&m
the
socket clockwise until it locks in place.
Install the lamp assembly and screws.
Close the endgate.
Underhood Lamp
1. Disconnect the electrical connector from the
underhood lamp assembly.
2. Remove the screws.
3. Disconnect the ground wire.
4. Remove the lamp assembly from the hood.
5. Install the new bulb.
6.- Replace the ass.embly. Install and tighten the screws.
7. Connect the ground wire.
8,. Connect the electrical connector to the lamp assembly.
'
6-33