Murray 425014X92E Instruction Book page 22

6. Connect anti-sway bar to chassis
bracket and secure with retainer spring.
7. Push clutch cable housing guide into
bracket, slide collar onto guide and
secure with large retainer spring.
8. Place fl at washer and clutch spring on
idler pulley bolt and secure with small
retainer spring.
9. Install belt onto engine pulley.
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked
on level ground or driveway. Make sure
tires are properly infl ated (See "PROD-
UCT SPECIFICATIONS" section of this
man u al). If tires are over or underinfl ated,
you will not properly adjust your mower.
SIDE-TO-SIDE ADJUSTMENT
• Raise mower to its highest position.
• At the midpoint of both sides of mower,
measure height from bot tom edge of
mower to ground. Distance "A" on both
sides of mower should be the same or
within 1/4" of each other.
• If adjustment is necessary, make adjust-
ment on one side of mower only.
• To raise one side of mower, tighten lift
link ad just ment nut on that side.
• To lower one side of mower, loosen lift
link ad just ment nut on that side.
NOTE: Each full turn of adjustment nut
will change mower height about 1/8".
• Recheck measurements after ad just ing.
Bottom edge of
mower to ground
00598
A
Ground Line
Suspension Arm
Lift Link Adjustment Nut
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-to
side. If the following front-to-back adjust-
ment is necessary, be sure to adjust both
front links equally so mower will stay level
side-to-side.
To obtain the best cutting results, the
mower housing should be adjusted so
that the front is approximately 1/8" to 1/2"
lower than the rear when the mower is in
its highest position.
Check adjustment on right side of trac-
tor. Measure dis tance "D" directly in front
and behind the mandrel at bottom edge of
mower housing as shown.
• Before making any necessary ad just -
• If links are not equal in length, adjust
• To lower front of mower loosen nut "E"
• When distance "D" is 1/8" to 1/2"
• To raise front of mower, loos en nut "F"
• When distance "D" is 1/8" to 1/2" lower
• Recheck side-to-side ad just ment.
Bottom edge of
mower to ground
A
01553
22
ments, check that both front links are
equal in length.
one link to same length as other link.
on both front links an equal number of
turns.
lower at front than rear, tighten nuts "F"
against trunnion on both front links.
from trunnion on both front links. Tighten
nut "E" on both front links an equal num-
ber of turns. The two front links must
remain equal in length.
at front than rear, tighten nut "F" against
trun nion on both front links.
"D" "D"
Both Front Links Should be Equal in Length
Nut "F"
Trunnion
Front Links
01268
Mandrel
01267
Nut "E"