Operation; Cleaning - Prince Castle 840-T series Operating Instructions Manual

10. After pressing the ENTER button, the CHANNEL/
FUNCTION display will read D1T=DUTY 1 TIME  .
To move on to the DUTY 2 function press the
CHANNEL BUTTON once.The CHANNEL/
selected
FUNCTION display reads D2T=DUTY 2 TIME 
and :00 Seconds (The Factory Preset) will appear
in the TIME DISPLAY.
11. Repeat steps 6-10 for DUTY 2, DUTY 3, HOLD and
HOLD DUTY Settings. NOTE: The HOLD FUNC-
TION is preset at the factory for 2:00 M:S, if no
HOLD TIME is desired you must set the HOLD
FUNCTION to 00:00.
12. After you have completed programming the HOLD
DUTY FUNCTION, press the CHANNEL BUTTON
again, the display will read SEL CH/LOGO=QUIT.
Select another channel button to program, or press
the PRINCE CASTLE LOGO to return to the RUN
MODE.
13. You can change the sound level of the alarm in
RUN MODE. Press and hold the PRINCE CASTLE
LOGO ; then, within six seconds, press either the
SCAN UP Arrow button or the SCAN DOWN Arrow
button. The SCAN UP Arrow button adjusts the
sound level to the louder alarm, and the SCAN
DOWN Arrow button adjusts the sound level to the
lower alarm.

OPERATION

1. Press a channel button to activate a timing cycle.
(All channels can be activated and running at the
same time.) The channel with the least amount of
function time remaining will be displayed in the
CHANNEL/FUNCTION display along with the next
function. The time remaining will countdown in the
TIME display, and the time value M:S or H:M will be
illuminated.
1 - COOK
3 : 0 0
2. Press the desired channel button three times within
five seconds to cancel an active timing cycle.
Printed in USA 4/07 © 2007
IMPORTANT: The channel timer button's multi-
colored LED indicator shows the status of the
timer. The indicator has three colors: green,
yellow, and red. The LED will be green during
the first 70% of the countdown. It changes to
yellow during the next 20% of the countdown. It
will be red during the final 10% of the countdown,
and will start flashing red once the time has run
out.
Note: If a Manual Cancel is programmed into a
duty function the LED will flash red until the
channel button has been pressed. If an Auto-
matic Cancel is programmed the LED will flash
green for 5 seconds and the alarm will automati-
cally turn off.
3. The timer will countdown from the programmed
value to zero. When the complete cooked time is
finished, the display flashes 0 0 and the alarm
sounds.
4. When the timing cycle is complete, and the alarm
sounds, press the channel button with the flashing
red indicator to cancel the alarm.
5. The scan feature is used to check the time values on
other active channels. There are two different ways
to scan active channels. Press the SCAN/UP or
SCAN/DOWN button.Or press any of the active
timer CHANNEL buttons. If no other button is
pressed within 5 seconds, the display will change to
show the timer with the least amount of time left.

CLEANING

1.Do not allow grease to build up on the timer, wipe it
down daily with clean damp cloth.
IMPORTANT: Do not use abrasive or chemical cleaners
on your timer, this may cause damage to the overlay.
ENTER
4
840-507revC